Cricut: | Silhouette Cameo: | Scan N Cut: |
Blade: Standard | Blade: Standard, 3 | Blade: Standard, 2 |
Setting: Iron-on | Material: Heat Transfer, Smooth | Cut Speed: 1 |
Speed: 8 | Cut Pressure: 1 | |
Force: 6 |
Roland GS/GX-24: | Graphtec: | MH, SC2, LP3, and Titan 1: | Titan 2 & 3: |
Blade: 45° | Blade: 45° | Blade: 45°/60° | Blade: 45°/60° |
Gram Force: 80-90 | Gram Force: 8-9 | Gram Force: 80-85 | Gram Force: 60-65 |
Offset: .250 | Tool: CB09U+0 | Speed: 300mm/s | Speed: 300mm/s |
Speed: 25-50 cm/s | Speed: 30 cm/s | *Blade Advancing Varies | *Blade Advancing Varies |
*Settings may vary based on blade condition and age of the machine. Always perform a test cut prior to cutting designs.
EasyWeed Applies to
100% cotton
Poly/cotton blends
100% polyester
Leather
Home Iron
- Set iron dial between Cotton and Linen
- Cover design with Kraft paper or non-stick cover sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 10-15 seconds
- If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
- Peel carrier hot or cold
Heat Press
- Cut in reverse
- Weed excess material
- Preheat garment for 2-3 seconds
- Apply design at 305°F/150°C
- Use medium pressure for 10-15 seconds
- Peel carrier hot or cold
Washing
Wait 24 hours before 1st wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean